- raise the glass;
- remove the door trim panel;
- remove the sealing element;
Pic. 11.35. Pull Removal: 1 - thrust
- remove the rod 1 from the clamps (pic. 11.35), linking the outer handle;
Pic. 11.36. Removing the inner handle: 1 - fastening elements; 2 - latches; 3 - inner handle
- remove the inner handle 3 (pic. 11.36), by pulling the handle towards the hinges;
- open latch 2;
- remove fasteners 1;
Pic. 11.37. Removing the door opening mechanism: 1 - pin connector; 2 - door opening mechanism; A - hole
- disconnect pin 1 (pic. 11.37);
- remove the connecting element with the control unit from the latches;
- remove the entire mechanism 2 assembly by turning it to remove the pin from the lock;
- Remove the mechanism assembly through hole A.
Install the front door opening mechanism in the following order:
- connect the wiring harness of the control unit after removing it;
- install new sealing elements, which must be installed without folds and tears, thoroughly clean the surface pressed against the door panel;
- Complete installation in the reverse order of removal.