Removing
Raise and secure the vehicle so that the front wheels are off the floor.
Remove the wheel and mudguard.
Note. The work on the left and right sides of the car is similar.
Disconnect the connector in the area «b».
Disconnect the wheel sensor harness in the area «A».
Remove the bolt (1) and remove the wheel sensor (2).
Installation
Attention. Do not strike the sensor head.
Check the cleanliness of each wheel sensor (2).
Install sensors.
tighten bolt (1), having previously applied the composition to the thread «Loctite Frenetanch» (see tightening torques in section 5 «Brake system»). Connect the connector in the zone «b». Connect the wheel sensor harness in the area «A».
Install mudguard and wheel. Lower the car onto its wheels. Carry out road tests. Read fault codes.