Table of contents: Removal 🠇 Installation 🠇
Removal
Raise and support the vehicle with the rear wheels off the ground. Remove the rear wheels.
Note: The work on the left and right sides of the car is similar.
Remove the wheel sensor screw (1) through the wheel bolt hole using a hex key.
Disconnect connector "a".
Disconnect the wheel sensor electrical harness.
Remove the wheel sensor (2) (as shown by the arrow).
Installation
Caution: Avoid impacts to the sensor head.
Note: The gap is not adjustable.
Check the cleanliness of each wheel sensor (2).
Install the wheel sensor (2) and bolt (1) (see tightening torques in section "Brake system").
Connect the wheel sensor electrical harness.
Connect connector "a".
Install the rear wheels.
Conduct a road test.
Perform a fault code reading.