- disconnect the negative battery cable;
- remove the wiper arms from the shafts;
- on petrol models, remove the air duct connecting the air cleaner to the intake manifold;
- remove the seal from the top end of the bulkhead, then, starting from the middle and moving towards the edges, disconnect the left section of the water separator;
Figure 10.10. Removing the water shut-off fasteners: 1 - clamps
- disconnect the clamps 1 (figure 10.10) left section from the right and remove it from under the windshield;
Figure 10.11. Fastening bolt: 1 - bolt
Source can be seen at: peugeotbook.ru
- remove bolt 1 (figure 10.11) mounts located under the windshield wiper motor;
- unscrew the nuts securing the levers on each shaft, remove the washers and disconnect the electric drive from the body;
- disconnect the electric motor connector and remove the electric drive from the vehicle;
Figure 10.12. Lever mechanism rod: 1 - nut; 2 - bolts
- mark the position of the electric drive shaft relative to the crank, then unscrew nut 1 (figure 10.12) fasteners, remove the washer and disconnect the lever mechanism rod from the drive shaft (figure 10.12);
- unscrew the 2 mounting bolts and disconnect the electric drive from the lever mechanism.
Install the windshield wiper electric drive in the reverse order of removal.