- disconnect the negative battery cable;
- remove the windshield wiper arm;
- open the trunk door and remove the trim panel from it;
- drill out the rivets securing the windshield wiper motor bracket with a 7.5 mm drill. To prevent the rivet from getting inside the door, place a rag behind the motor;
Note: When drilling out the rivets, be careful not to damage the electric drive components and the tailgate.
Figure 10.13. Disconnecting the contact connector
- disconnect the contact connector and remove the electric drive from the door (figure 10.13);
- do not allow the bushings to fall out of the rubber bracket supports;
- remove the rubber seal of the electric drive from the door glass;
- remove the remaining rivets from the bracket;
Figure 10.14. Removing the windshield wiper drive bracket: 1 - bolt
- remove three bolts 1 (figure 10.14) and disconnect the electric drive from the bracket.
Install the electric windshield wiper drive for the luggage compartment door in the following order:
- before installation, inspect the sealing bushing and rubber supports, make sure there is no damage or wear of parts. Replace faulty parts;
[The source is located on the website: Peugeotbook.ru]
Figure 10.15. Installing the sealing sleeve: 1 - bushing
Figure 10.16. Bracket rubber bushing: 1 - bushing
- insert sealing sleeve 1 (figure 10.15) into the door glass hole and make sure that the rubber bushing 1 (figure 10.16) did not fall out of the electric drive bracket;
- install the electric drive and secure it with new rivets;
- connect the contact connector;
- install the wiper arm;
- connect the wire to the negative terminal of the battery.