Attention: Follow the specified sequence.
Remove the threaded pin in area "c".
Install the cotter pin (55) and fixture 12.
Tighten the four screws "d" to a torque of 15 Nm.
Place the threaded pin in zone "c" and tighten it until it stops.
Caution: Make sure the tool is in the correct position to ensure proper installation of the pin (55).
Gearbox without 5th gear/reverse gear inhibition system
Install pins (56) and (57).
Install:
- secondary shaft bushing (60);
- magnetic record (61);
- adjustment mechanism (63):
- locking finger (64).
Install the rear gear fork (62) with its axle (59), tighten the nut to 45 Nm.
 |
 |
Install the gear selector shaft (58).
Install:
- seal (68) (new);
- washer (69);
- adjustment mechanism (65);
- selector lever (67);
- hairpins (66).
Source available on the website: PEUGEOTBOOK
Caution: Make sure that the magnetic plate (61) is in place.