Note. Mark the position of the bellows in the area «A».
Remove the hinge (3) using tools 6 and 7.
Remove retaining ring (4) and corrugated cover (5).
Remove as much of the old grease as possible.
Special fixtures:
1 - clamp for clamps 2483-T;
2 - extractor 2405T/4108T;
3 - tripod hinge puller 4183-T.E;
4 - mandrel for mounting tripod hinge 4101Т.С;
5 - clip for clamps CLIC4178T;
6 - inertial puller 1671T;
7 - threaded bushing 4083T;
8 - mandrel for installing the tripod hinge 4101T.BZ;
9 - protective elements of roller joints type «tripod» 4101T.J1, J2, J3, J4;
10 - pliers for OETIKER clamps;
11 - mandrel for installing tripod hinge 4608 TG
Attention. Do not use solvent.
Install a new protective cover (5) and a new retaining ring (4).
Install clamp (6) on the retaining ring to facilitate pressing the CV joint.
Install CV joint (3) onto the shaft using tools 6 and 7.
Remove clamp (6).
Fill the bellows with all the grease in the repair kit (quantity 160 g).
Install protective cover (5).
Attention. Make sure that the corrugated cover is installed correctly, according to the previously applied mark in the area «A».
Install new clamps (1) And (2) with tool 5.