Remove clamps (7) And (8) with a metal hacksaw.
Slide the protective cover onto the drive shaft, releasing the CV joint.
Remove:
- external hinge (9);
- adjustment mechanism (10);
- retaining ring (11) with roller mechanism.
Attention. When removing the ring, do not damage the roller mechanism.
Install the protective element 9 on the roller triode hinge.
Remove as much of the old grease as possible.
Remove the tripod joint (12) using tool 3 and a press.
Remove the old bellows (13) and install a new one in its place.
Install the tripod hinge (12) using mandrel 11 and a hammer.
Fill the tripod joint with new grease from the repair kit (quantity 130 g).
Install on a tripod (11) new circlip, spring (10) and outer hinge (9).