Lifting a car with a jack (Peugeot 206)

Figure 1.5. Jack installation locations

The car is lifted using a jack from the driver's tool kit, a garage jack or a stationary lift at a service station. The jack installation points on each side of the body have corresponding support sockets (are shown by arrows in Figure 1.5). When using a garage jack or lift, use the same points on the vehicle body.

Source available on the website Peugeotbook.ru

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article reviewed by editor: Matveev Demid

Share information:

Peugeot 206: User manual

Starting the engine from an auxiliary source
Vehicle identification data
General information about Peugeot 206 cars

Towing a car and driving with a trailer
Wheel replacement
Controls and instruments
Car keys and ignition switch
Control indicators

See similar information for other Peugeot models

➨ Replacing the sliding and lifting roof panel assembly Peugeot 307 (2001-2008)
➨ Lifting and installing the car on supports Peugeot Partner I (1996-2008)

Link to this article in different formats

TEXTHTMLBB Code

Comments and feedback from visitors