Disconnect the windshield washer tube retainer (1).
Disconnect the washer pipe at the connection point (in the zone «A»).
Loosen the nuts (2) and remove the hood (3).
Bonnet Hinge Lever
Remove the air intake grille (see section 7 «electrical equipment»).
turn away (from each side) fastening bolts (4) And (5) and remove the hood hinge lever (6).
Soundproofing and windshield washer jets
Use the tool [1] to release the fasteners (7).
Remove the hood soundproofing (8).
Disconnect the washer tube from the jets (in the zone «b»).
Disconnect the washer jet (9) (in the zone «With») and remove.
Installation
Install the parts in reverse order.
Perform gap adjustment and hood alignment (see later in this section).
Tightening torques
- nuts (2): 10 Nm.
- Bolt (4): 5 Nm.
- bolts (5): 10 Nm.
Note. Check the function and adjustment of the washer jets.