Hood lock
Turn away bolts (1).
Move the lock (2).
Disconnect the hood release cable (3) (in the zone «A»).
Remove the lock (2).
Hood lock cable
Note. To disconnect the cable on the lock, it must be removed.
Switch off the ignition.
Disconnect the battery.
Remove the front bumper and headlights.
Remove the battery and its bottom tray.
Disconnect the hood release cable (see above).
Note. Mark the original cable routing.
Remove the front pillar trim (see below).
Turn away bolts (4).
Move the cable lever (5), the BSI unit from its support, wiring harnesses.
Turn away bolts (6).
Remove the BSI block support (7).
Remove the hood release cable (3).
Remove the hole plug (8) for the passage of the cable from the front shield.
Remove the hood release cable assembly (3) and lever (5).
Installation
Install the parts in reverse order.
tighten bolt (4) torque 6 Nm.
Check for a soundproofing plug with a hole for draft (9).
Install and tighten bolts (1). Turn away bolts (1) ¼ turn.
Close the hood.
Adjust gaps and align elements (see below).
Open the hood.
Tighten the bolts (1) torque 10 Nm.