Loosen the mounting screws (1) and remove the brackets (2) using a thin screwdriver.
Release the rear bumper (3) (in areas "a" and "b") (the operation is performed symmetrically).
Disconnect the clamps (4).
Disconnect the connector (in area "c") (depending on the configuration).
Remove the rear bumper (3).
Rear bumper bracket
Remove the tail lights.
Drill out the rivets (5) with a 6 mm drill.
Note: Remove rivet pins before drilling.
Remove the rear bumper side bracket (6) (the operation is performed symmetrically).
Article based on material from the website Peugeotbook.ru
Drill out the remaining rivets.
Install the parts in reverse order.
Apply anti-corrosion treatment to areas with rivet holes.
Check the correct functioning of the electrical equipment.
