Front door replacement (Peugeot 207)

Place the support [1] under the front door (1).





Loosen the bolts (2).

Slide the front door (1) in the direction of arrow "A".



Move aside the door wiring harness cover (3).

Disconnect the connectors (4).

Remove the front door (1).

Note: To access the door bolt (5), the front wing seal must be removed.

Remove the front fender liner.

Disconnect the retainer (12) of the front wing trim (13) using a thin screwdriver and remove the trim.

Installation and adjustment

Loosen the fastening of the bolts (5) of the hinges (6).

Note: If more door clearance adjustments are required, the positioning pin (7) can be removed using a pin extractor.

Loosen the bolt (9) and remove the centering pin (8).



[Original text is located at: Peugeotbook.ru]

Loosen the bolts (10) a quarter turn so that the door closes without hitting the bracket (11).



Install the door (1) using the support [1].



Reconnect the connectors (4). Tighten the bolts (2).

Loosen the bolts (2) again by ¼ turn.

Tighten and loosen the bolts (5) of the hinges (6) by ¼ turn.

Align the gaps of the front door with the front wing and the rear door (in zones "B", "C", "D").



Adjust and check the gaps and align the door at the points "E", "F", "G", "H", "I" using bolts (2), (5), (10).



After completing the adjustment, tighten:

• bolts (2) with a torque of 19 Nm;
• bolts (5) with a torque of 19 Nm;
• bolts (10) with a torque of 17 Nm.

Check the door for leaks.

Install the parts in reverse order.

Check the operation of electrical equipment.