Turn away bolts (2).
push back the door (1) in the direction of the arrow «A».
Move the door wiring harness cover (3).
Disconnect connector (4).
Remove the door (1).
Installation and adjustment
Open the front door.
Loosen the bolts (5) loops (6).
Note. If more door gap adjustments are needed, the positioning pin can be removed (7) using a pin extractor.
Loosen the bolt (9) and remove the center pin (8).
Loosen the bolt a quarter of a turn (10), to enable the door to be closed without touching the bracket (11).
Install the door (1) using the support [1].
Reconnect the connectors (4).
Tighten the bolts (2).
Loosen the bolts again (2) ¼ turn.
Tighten and loosen ¼ turn bolts (5) loops (6).
Adjust and check gaps and align door with bolts (2), (5), (10).
After adjusting, tighten:
- bolts (2) torque 19 Nm;
- bolts (5) torque 19 Nm;
- bolts (10) torque 17 Nm.
Check the tightness of the door.
Install the parts in reverse order.
Check the operation of the electrical equipment.