Table of contents: Checking the runout (the wheel is…🠇 Thickness check 🠇
Checking the runout (the wheel is installed)
Secure and raise the vehicle on a two-post lifting platform.
Install the magnetic support on the lower control arm.
Attach the indicator to the magnetic support.
Place the indicator probe 10 mm from the edge of the brake disc.
To check the runout of the front brake disc, move it using the wheel drive shaft.
Make a full revolution of the brake disc.
Permissible runout of the brake disc installed on the hub: less than 0.05 mm.
[You can find the original on the resource: www.PeugeotBook.ru]
Thickness check
Use a micrometer with a step of 0/50 mm.
Maximum difference in thickness in one plane: 0.01 mm.
