Disconnect the generator power connector (in the zone «A»).
Remove the accessory drive belt (1) (see section «Engine and control systems»). Loosen the power cable nut (4).
Turn away bolts (3) generator mounts.
Move the tension roller (2) and generator wiring harness.
Attention. Be careful when working with a locked idler to prevent it from unlocking (risk of injury).
Remove the bolt (6) and remove the alternator (5) (through the top).
Note. When installing the generator, check the presence of centering bushings.
Attention. Replace the cable tie on the idler pulley if it has been sheared off (short circuit danger).
Install the parts in reverse order.