Throttle valve operating modes:
C - throttle valve rest position (contact open) or emergency mode position in case of malfunction;
D - throttle position with ignition on or idle;
E - throttle position at full throttle;
4f - throttle actuator force;
4g - spring force.
Place the car on a lift.
Remove:
- right front wheel;
- mudguard under the engine;
- right mudguard;
- side turn signal repeater.
Disconnect the fuel pipes in area "c" and close the holes with plugs.
Release the adsorber in zone "a" by pressing the springs in zone "b".
Remove the adsorber (1).
Note: If necessary, replace the fasteners in area "a" before installation.
Install the parts in reverse order.
Connect the battery.