- open the hood;
Figure 10.46. Location of the fasteners (1) of the upper fastening of the front wing
- remove the clamps 1 (figure 10.46) the upper front fender mounts by turning each of them a quarter turn;
- open the front door;
Figure 10.47. Location of screws (1) for rear fastening of front wing and directions (A) for detaching wing
- remove screws 1 (figure 10.47) rear front fender mount;
- detach the front fender by moving it away from vehicle A;
Figure 10.48. Location of screws (1) and clamp (2) for the lower fastening of the front fender
- unscrew screws 1 and remove retainer 2 (figure 10.48) lower front fender mount;
Figure 10.49. Location of fasteners (A) for fastening the front part of the wing
- remove the front part of wing A from the clips (figure 10.49), be careful not to break the fasteners when doing this;
- disconnect the electrical connector from the side turn signal repeater;
(Source available here: PeugeotBook)
Figure 10.50. Location of the absorber protrusion (1) in the front right wing
- remove the front fender from the car. When removing the right wing, take care not to break the absorber protrusion 1 (figure 10.50).
To install the front fender:
- when installing the right front wing into place, install the absorber protrusion 1 into the groove, being careful not to break it;
- connect the electrical connector to the side turn signal repeater;
- install and adjust the position of the front fender;
- screw in the upper wing mounting screw from the front pillar side;
- install the clamps 1 (see Figure 10.46) upper wing mounts and rotate them a quarter turn;
- from the front pillar side, screw in the lower and middle wing mounting screws;
- secure in clamps A (see Figure 10.49) front part of the wing;
- screw in screws 1 (see Figure 10.48) and install the clamp 2 of the lower fastening of the front wing.