- disconnect the ground wire from the battery;
- release the latches by inserting two thin screwdrivers into the holes on the sides of the block and pressing them;
- remove the car radio from the socket so that its back wall is visible;
- disconnect the electrical connectors and ground bus from the rear of the car radio;
- remove the car radio.
Installation is carried out in the reverse order of removal, taking into account the following:
- connect the ground wire to the battery;
- check the functionality of the car radio;
- when replacing a car radio, it is necessary to configure the telecoding parameters using the DIAG 2000 device;
- initiate all electronic systems.
Article based on material from the website (peugeotbook.ru)