Heating and ventilation controls (Peugeot 307)

Air distribution handle

Air supply to the windshield and side windows (to remove condensation and frost).

To quickly remove frost and condensation from the windshield and side windows, do the following:

• install the air recirculation button 2 (figure 1.51) into the cabin in the "Outside air" position (when button 2 is released, the signal lamp does not light);
• set the temperature and incoming air speed controls to the maximum position;
• close the central and side ventilation grilles.

Air supply to the windshield and side windows, as well as to the passengers' feet.

Air supply to the passengers' feet.

Air supply to the central and side ventilation grilles.

Air recirculation mode activation button.

By pressing button 2, the air recirculation mode in the passenger compartment is activated, and the indicator lamp lights up. The recirculation mode allows you to isolate the interior from unpleasant odors and smoke from the outside.



As soon as possible, to prevent the windows from fogging up and the atmosphere inside the car from getting worse, set button 2 to the outside air supply position. When recirculation is switched off, the indicator lamp goes out.

Air temperature control knob

Control knob 4 allows you to set the desired air temperature in the cabin.

The temperature increases gradually when you turn the knob clockwise.

Air flow rate adjustment knob

Turn control knob 5 from position "1" to position "4" to ensure sufficient air enters the passenger compartment to provide the required comfort.

Rear window defroster switch

The rear window and outside mirror heaters are activated by a single button and operate only when the engine is running.



The electric heaters are designed to turn off automatically after approximately 12 minutes. Pressing the button again turns the heaters on for 12 minutes.

You can force the electric heaters to turn off before 12 minutes have passed by pressing the button again.