Series 100 Series 200 Series 300 400-500 Series 600 Crossovers Others

Peugeot 206 (1998-2012) Peugeot 207 (2006-2014)

Filling the hydraulic circuit of the power steering (Peugeot 207)

0

Caution: Open the circuit carefully to prevent contamination particles from entering it.

Install new gaskets (4).

Install new gaskets (4).

Install the clamp (3), bolt (2) and screw in area "a".

Install the steering gear heat shield.

Install the steering gear heat shield.

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article reviewed by editor: Matveev Demid

Share information:

Previous

Peugeot 207: Steering

Next

Draining fluid from the hydraulic circuit of the power steering
Checking the pressure in the power steering circuit
Steering wheel angle sensor
Power steering pump control unit
Executive mechanism (power steering electric pump unit)

Bleeding the hydraulic circuit of the power steering
Removal and installation the steering wheel
Removal and installation the steering wheel angle sensor
Removal and installation of steering rods
Adjusting the rack's middle position

See similar information for other Peugeot models

➨ Power steering hydraulic system — bleeding Peugeot 106 (1991-2003)
➨ Draining and filling fluid, removing air from the hydraulic… Peugeot 306 (1993-2002)
➨ Power steering pump (XU9J4) (10000 km/6 months) Peugeot 405 (1987-1997)
➨ Power Steering Pump — Removal and Installation Peugeot 605 (1989-2000)
➨ Power steering — draining and filling fluid, bleeding air Peugeot 806 (1994-2002)

Link to this article in different formats

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

Cookies are used to ensure the correct display of pages on the site.