Attention. Open the circuit carefully to prevent dirt particles from entering it.
Use new fluid to bleed and top up the hydraulic steering circuit.
Note. The power steering fluid must be drained with the engine off.
Remove the protective cover.
Open the fill plug (1).
Raise and secure the vehicle so that the wheels are off the floor.
Slide the heat shield on the steering gear.
Loosen the screw in the area «A».
Release the pipes installed next to the power steering valve.
Remove the bolt (2).
Release the mount (3) power steering valve.
Attention. Use a clean tool and be careful not to damage the power steering valve.
Route the hoses into the tank.
Turn the steering wheel to the extreme position in each direction.
Wait until the liquid stops flowing out.