Table of contents: Removal 🠇 Installation 🠇
Removal
Remove the clutch mechanism (see section 3 "Transmission").
Fix the double damper flywheel in a stationary position using tool 1.
Recommended accessories:
1 - flywheel stopper 0188-R;
2 - device for installing dual flywheel 0216-L.
Remove the six dual damper flywheel mounting bolts.
Remove the dual damper flywheel.
Remove flywheel stopper 1.
Check for the presence of the centering pin.
Screw the two threaded rods of tool 2 into the crankshaft in place of the two mounting bolts located opposite the dual damper flywheel.
Remove the dual damper flywheel (1).
Installation
Center the dual damper flywheel using the centering cones and knurled round nuts of tool 2. Install the bolts (2) (without delay). Remove device 2.
Replace the last two bolts (2).
Install flywheel stopper 1.
 |
 |
Note: When removing the dual damper flywheel, use new bolts to secure it each time.
Tighten the bolts (2) crosswise. Remove the flywheel stopper 1.
Install the clutch mechanism (see section 3 "Transmission").