Table of contents: Intake manifold 🠇 Exhaust manifold 🠇
Intake manifold
1. Disconnect the negative cable from the battery.
2. Remove the air cleaner (see section 3) and disconnect the air duct from the intake manifold (see photo).
3. Remove the brake booster vacuum pump from the intake manifold (see chapter 8). Disconnect the pump outlet hose from the manifold (see photo).
4. Loosen the bolts with a hex key and remove the intake manifold from the cylinder head (see photos). The manifold does not have a gasket.
 |
 |
5. Installation of the intake manifold is carried out in reverse order. Tighten its mounting bolts evenly.
Exhaust manifold
6. Apply the handbrake and jack up and support the front of the car.
7. Unscrew and remove the bolts securing the exhaust manifold to the exhaust downpipe, along with their springs and rings. Tie the downpipe to the side so it doesn't get in the way.
8. Unscrew the nuts and remove the exhaust manifold from the studs on the cylinder head. Remove the gaskets (see photos).
 |
 |
9. Where applicable, unscrew the bolts securing the resonator to the manifold and remove it with the gasket.
10. Installation of the exhaust manifold is carried out in reverse order. Clean all contact surfaces and install new gaskets. Tighten the manifold mounting nuts evenly (see photo).
