 |
 |
2. Assemble the oil pump parts (see section 28).
3. Check that the plunger, spring and plug of the relief valve are absolutely clean, lubricate them with clean engine oil and install them in place next to the filter seat (see photos), replacing the sealing washer with a new one.
 |
 |
4. Install the oil pressure sensor with a new sealing washer (see photo).
5. Install the distributor clamp plate and secure it with a bolt and lock washer.
6. Install a new O-ring onto the oil transfer sleeve on the cylinder block surface next to the tensioner plate (see photo).
7. Install a new timing case gasket onto the cylinder block, securing it in place with sealant (see photo).
8. Install the timing case. After installing the casing, carefully trim off any excess gasket protruding above the surface of the valve cover (see photos).
 |
 |
