Attention! The radiator cover is connected to the front bumper. To remove the bumper clamps, it is necessary to make a hook from steel wire by bending the end of the wire 10 m long at an angle of 90°.
To remove the front bumper:
- remove the headlight washer jets;
- remove the mudguard under the engine;
- release the front parts of the mudguards of the arches of the right and left front wheels;
- unscrew the side mounting screws from under the bumper;
Pic. 10.34. Releasing the latches (2) fastening the bumper with a self-made hook (1)
- release the bumper fasteners, for which insert the self-made hook, as shown in fig. 10.34, and turn it a quarter of a turn;
Pic. 10.35. Screw location (1) and clamps (2) front bumper mounts
- unscrew the two screws 1, release the four locks 2 (pic. 10.35 am) front bumper mounts;
- pull forward to remove the front bumper from the vehicle, being careful not to damage the radiator grille when removing the hood latch.
To install the front bumper:
- install the bumper and secure it with clips on each side;
- Carry out further installation in the reverse order of removal.