2. Install the box on the pins, insert the bolts and tighten them.
Models up to September 1986
3. Install the bottom cover and tighten its bolts.
4. Install the starter and tighten its bolts.
5. Install the w.m.t. sensor. with the holder and tighten its bolts. The new sensor w.m.t. there are three 1.0 mm long supports that automatically position the sensor 1.0 mm from the flywheel. When installing an old sensor, the supports should be filed down, after which the sensor can be inserted all the way so that it touches the flywheel, and then pulled out 1.0 mm and fixed in this position with bolts.