- lower the glass down as far as it will go;
- turn off the ignition and disconnect the ground wire from the battery;
Figure 10.10. Fastening the front door trim: 1 - screws; 2 - inner lining of the outside mirror; 3 - decorative trim for the interior door handle; 4 - switches; 5 - screw; 6 - front door trim
- remove screw 5 (figure 10.10) switch mounts;
- remove switches 4 from the front door trim;
- use a screwdriver blade to pry up and remove the inner trim 2 of the outside mirror;
- turn the inside door opening handle to the open position;
Figure 10.11. Using a spatula (2) to remove the decorative trim (1) from the interior door handle
- using a spatula 2 (figure 10.11), installed above the handle axis, release the decorative trim 1 of the inner door opening handle from the clips;
- pull the decorative trim away from the door and remove it;
- remove screws 1 (see Figure 10.10) door trim fastenings on the front and rear edges of the door;
- using a special trim removal clamp 1311 or a homemade device in the form of a flat fork, release the door trim from the clips around the perimeter. Do not apply too much force to avoid breaking the fasteners;
- disconnect the electrical connector from the front door speaker;
- remove the front door trim panel.
Information copied from the resource: PeugeotBook.ru
Installation is carried out in the reverse order of removal, taking into account the following:
- connect the ground wire to the battery;
- check the functionality of electrical equipment;
- initiate all electronic systems.