Replacing the front door lock (Peugeot 307)

• lift the glass up to the stop;
• turn off the ignition and disconnect the ground wire from the battery;
• remove the front door trim panel from the inside rear side;

Figure 10.12. Removing the front door lock: 1 - screws; 2 - screws; 3 - internal door opening handle; 4 - thrust; 5 - dust and moisture protective film; A - hole in the inner door panel

• remove the inner handle 3 (figure 10.12) opening the door by pulling it towards the door hinges;
• release the rod 4 of the inner door opening handle from the clamps;
• remove screws 1 securing the rear door glass guide;
• remove the rear door glass guide through hole A in the inner door panel;
• remove the three screws 2 securing the door lock;

Figure 10.13. Removing the electrical connector: 1 - electrical connector; 2 - outer door opening handle rod; 3 - front door lock rod

• peel off the dust and moisture protective film 5 from the top and bottom, disconnect the electrical connector 1 (figure 10.13) doors;
• disconnect rod 2 from the outer door opening handle lever;
• disconnect rod 3 from the front door lock lever;
• remove the front door lock through the hole in the inner door panel.

• secure the dust and moisture protection film, installing it without folds or tears;

Caution! Connect the control unit electrical harness only after removing it.

• clean the surface to which the dust and moisture protective film is glued;
• further installation is carried out in the reverse order of removal, taking into account the following:
• connect the ground wire to the battery;
• check the functionality of electrical equipment;
• initiate all electronic systems.