- lift and secure the vehicle, leaving the rear wheels off the ground;
- remove the rear wheels;
Figure 6.40. Location of rear brake components: 1 - calipers; 2 - brake disc; 3 - protective cap
- unscrew the bolts, remove the rear brake caliper 1 (figure 6.40) and tie the caliper to the body with soft wire. The caliper should not hang on the brake hose;
- using a screwdriver blade as a lever, remove the protective cap 3 covering the hub mounting nut;
- unscrew the bolt and remove the brake disc;
- remove the ABS sensor;
Figure 6.41. Location of bolts (1) for fastening the rear wheel hub axle
- on the back side of the rear brake cover, remove the four bolts 1 (figure 6.41) and remove the hub, bearing and hub axle as an assembly.
To install the hub assembly:
- install the hub axle and secure it with bolts, after applying a thin layer of FREIN FILET grease to the bolt threads;
- tighten the bolts to 63 Nm;
- install the ABS sensor and secure it with the bolt, tightening it to a torque of 8 Nm;
- install the brake disc and secure it with the bolt, tightening it to a torque of 10 Nm;
- install the caliper and secure it with bolts, tightening them to a torque of 53 N·m;
- install protective cap 3 covering the hub mounting nut;
- install the wheels.
Article republished from the website: www.peugeotbook.ru