Crankshaft — General Information (Peugeot 206)
The crankshaft is mounted on 5 main bearings. The axial clearance of the crankshaft should be within 0.07-0.32 mm. The axial clearance is adjusted using four thrust half rings with flanges mounted on the second main bearing.
This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Article reviewed by editor: Matveev Demid
Share information:
See similar information for other Peugeot models
➨ Crankshaft oil seals — renewal Peugeot 106 (1991-2003)
➨ Pistons, connecting rods and crankshaft — removal Peugeot 305 (1977-1989)
➨ Replacing crankshaft seals Peugeot 405 (1987-1997)
➨ Front crankshaft oil seal (timing belt side) — replacement Peugeot 605 (1989-2000)
➨ Crankshaft and flywheel — removal, inspection and installation Peugeot 806 (1994-2002)
Link to this article in different formats
Comments and feedback from visitors
No comments yet
- General information
- Car care
- Governing bodies
- Driving and operation
- Power unit
- Engine characteristics
- Engine repair
- Cooling system
- Lubrication system
- Ignition system
- Control system (gasoline)
- Fuel system (gasoline)
- Control system (diesel)
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Drive shafts
- Chassis, running gear
- Car suspension
- Steering
- Brake system
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Heating and air conditioning
- Electrical equipment
- Equipment and devices
- Headlights and lighting
- Power devices
- Electrical circuits
- General information
- User manual
- Maintenance
- Power unit
- Gasoline engines
- Diesel engines
- Diesel power system
- Engine management system
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Drive shafts
- Chassis, running gear
- Front suspension
- Rear suspension
- Steering
- Brake system
- Body and interior
- Body elements
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Electrical circuits