- universal puller Facom U53T;
- device for installing the locking ring of the input shaft;
- fixture for mounting the input shaft bearings.
Disassemble the input shaft in the following order:
- dismantle the gearbox as described above and remove the primary, secondary shafts and differential;
Pic. 6.68. Removing the input shaft bearing from the 4th gear side: 1 - bearing
- press bearing 1 (pic. 6.68) from the 4th gear side using the tool shown in the figure;
Pic. 6.69. Removing the input shaft bearing from the 1st gear side: 1 - bearing
- press bearing 1 (pic. 6.69) from the 1st gear side using the tool shown in the figure;
Assemble the input shaft in the following order:
Attention! Removed bearings must be replaced each time. Check input shaft gear teeth and bearing surfaces.
Pic. 6.70. Installing the input shaft bearing on the 1st gear side: 1 - bearing
- press in new bearing 1 (pic. 6.70) from the gear side of the 1st gear using the tool;
Pic. 6.71. Installing the input shaft bearing on the 4th gear side: 1 - bearing
- press in new bearing 1 (pic. 6.71) on the 4th gear side, while orienting the bearing so that groove A is pointing up.